PS(φ6)series
(stainless-steel bolt M3)
Easy-work with using both left and right-tightening in pairs, in case of symmetry.
Cross 90°hole
for right-angle shaft attachment
φ13x25
Cross 45°hole
for use in pairs.
For attachment at an angle.
φ13x25
One-sided boss
for free assembly with other parts
φ13x14+L
Vertical-horizontal hole
for flame support or T-shape attachment.
φ13x20
Screw tapped
for parts or board attachment
φ13x18
Support Rings
for PIJON positioning /
Slip prevention when screw loosening
φ17x7
positioning alignment, supported by PS237
Shelf plate support
for shelf plate
support or shaft stopper
φ13x14
Wall fixing
for fixing by 2-φ3.5 with shaft
φ19x12
Shaft-end
for strut base
φ15x11
3 direction hole
for multistage assembly of rack or flame
φ13x31
Horizontal two-shaft hole
for shaft or PS204 attachment
φ13x25
4 direction hole
for multistage assembly of rack or flame
φ13x37
Decorating ball
for attachment
on the shaft edge
sphereφ13
Female screw dwell
to combine with other parts for screw attachment
φ6x14(stainless steel)
1 bag for 2 parts
For hinge
one-side free with
the other side fixed
φ15x31
Parts attachment
for sensor or parts attachment
6x6x44
1 bag for 2 parts
Parts attachment
for sensor or parts attachment
φ6x60
(stainless steel)
1 bag for 2 parts
Corner for external tightening
to set the corner of flame assembly
23x23x18
Low-profile corner for External tightening
to be nearly flat for pipe and clamp top
23x23x13
Split T
to tuck without disassembling flame (capable of later attachment)
22x18x11
Split T
to tuck without disassembling flame (capable of later attachment)
15x18x11
Split Cross
to tuck without disassembling flame (capable of later attachment)
20x20x11
Two screw tapped
two screws to firmly fix parts
20x15x8
Horizontal hole
to raise horizontal and vertical shaft
18x26x8
Vertical hole
to fix vertical shaft
15x26x14
Flange
for lateral side or vertical shaft attachment
8x26x17
Joint
for additional joint of shaft
14x15x10
Joint
to use female screw.
For parts attachment
14x15x10
Vertical-horizontal hole
for flame support or T-shape attachment.
15x10x14
Vertical-horizontal hole
for flame support or T-shape attachment.
15x10x18
(
:pipe hole )
* For 300, 400 type, please match the mark on both edge phase on assembly.
※You may download 3D CAD drawings by clicking on the part number of interest.
