PC(φ9)series
(stainless-steel bolt M4)
Easy-work with using both left and right-tightening in pairs, in case of symmetry.
Cross 90°hole
for right-angle shaft attachment
φ15x34
Cross 45°hole
for use in pairs.
For attachment at an angle.
φ15x34
One-sided boss
for free assembly with other parts
φ15x19+L
Vertical-horizontal hole
for flame support or T-shape attachment.
φ15x27
Vertical-horizontal hole
for flame support or T-shape attachment.
φ15x24
PC220-PC224
Screw tapped
for parts or board attachment
Support Rings
for PIJON positioning / Slip prevention when screw loosening
φ25x8.5
positioning alignment, supported by PS237
Shelf plate support
for shelf plate support or shaft stopper
φ15x22
Shelf plate support
for shelf plate support or shaft stopper
φ15x19
Shelf plate-fixing
slip prevention for shelf plate in parallel with shaft hole
φ22x16
Shaft-end
for strut base
φ22x16
3 direction hole
for multistage assembly of rack or flame
φ15x42
4 direction hole
for multistage assembly of rack or flame
φ15x50
Horizontal two-shaft hole
for shaft or PS204 attachment
φ15x33
Decorating ball
for attachment on the shaft edge
sphereφ15
Dwell with stage
for attachment on croze
φ19x20
M4 screw attached
PC262-PC264
Dwell with female screw stage
for attachment on croze
φ19x20
For hinge
one-side free with
the other side fixed
φ19x42
Corner for external tightening
to set the corner of flame assembly
26x26x24
Corner for internal tightening
to set the corner of flame assembly
26x26x24
Split T
to tuck without disassembling flame (capable of later attachment)
30x24x16
Split T
to tuck without disassembling flame (capable of later attachment)
24x24x16
Split Cross
to tuck without disassembling flame (capable of later attachment)
30x24x16
Split Cross
to tuck without disassembling flame (capable of later attachment)
24x24x16
Split T for rail
to tuck a guide pipe (capable of later attachment)
27x24x16
Two screw tapped
for parts or board attachment
28x20x10
Horizontal hole
to raise horizontal and vertical shaft
22x32x10
Vertical hole
to fix vertical shaft
19x32x18
Flange
for lateral side or vertical shaft attachment
10x34x20
Joint
for additional joint of shaft
18x19x13
Joint
to use female screw.
For parts attachment
18x19x13
Vertical-horizontal hole
for L-shape attachment and horizontal hole / stuck at the bottom
22x32x18
Vertical-horizontal T shape
for vertical/lateral shaft attachment
22x32x22
(
:pipe hole )
* For 300, 400 type, please match the mark on both edge phase on assembly.
※You may download 3D CAD drawings by clicking on the part number of interest.
