Determination of Joint type(2)

(b) In case that the applicable joint type cannot be found in the above way.

(1) In case that T₂ is larger than
figures found in dimension table.
(T₂>maximum transmission torque capacity)
→ Choose the joint in the same type whose shaft diameter is one or
two levels larger.
(In this situation, chose a solid
shaft type and use it after
machining a hole.)
(2) In case that N (use revolution) is larger than
"normal revolution"in dimension table.
(N>joint normal revolution)
→ Apply forced-feed lubricationor
use Type KL, KF, or KFD.