Determine the joint type via the following procedures a, b and c , based on T2 (joint capacity) obtained in .
Compare the figure of T₂with the "maximum transmission torque capacity" shown in the table of this catalogue corresponding to the shaft diameter (size) determined in .

(a) In case that T₂is smaller than the figure of maximum transmission torque capacity(T₂≤maximum transmission torque capacity).

(1) In case that N (use revolution) is smaller than "normal revolution". (N≤joint normal revolution)		This joint type is the right one.
(2) In case that N (use revolution) is larger than "normal revolution" (N>joint normal revolution)		Choose the type from other dimension tables so that the figure N (use revolution) is smaller than "normal revolution" of the chosen one.

*Note: Maximum revolution here is the one under the premise with joint angle of less than 10°and with forced-feed lubrication. (shown in dimension table)
Normal revolution is to be considered as a half of maximum revolution under natural lubrication.