Products

Standard Type Universal Joint

Bearing Type KD

High Revolution Use Material S45C

  • This type is good for high revolution use, because needle bearings with grease sealed are used.
  •  A hole for a spring-pin attached should be machined together with a shaft at a location of ℓ/2.
  • Types of K-16 and larger come with grease nipple.
  • Select type BD, when you use a boot.
  • Designate new JIS or old JIS for key, when the type of shaft-hole shape is B or T.
  • A spring-pin is not attached for a joint with a key way.

shaft-hole shape

  • Type A
  • Type B
  • Type T
  • Type F

■Type KD Dimension Table

Attachment : spring-pin 2 pieces

KD-10 10 20 96 19 31 34 3 1.4 4 1.5 M4 3×20 0.07 0.14 2200 6
KD-12 12 25 115 23.5 37 41 4 1.8 4 1.5 M4 4×25 0.07 0.28 1700 12
KD-16 16 32 158 34.5 52 54 5 2.3 5 2.0 M5 5×32 0.07 0.61 1300 24
KD-20 20 42 188 37.5 62 64 6 2.8 5 2.0 M6 6×40 0.10 1.26 1000 44
KD-25 25 50 220 39.5 70 80 8 3.3 7 3.0 M8 8×50 0.10 2.02 880 61
KD-30 30 60 275 52.5 89 97 8 3.3 7 3.0 M8 10×60 0.12 3.49 730 108

※You may download 3D CAD drawings by clicking on the part number of interest.