• 設計及び問い扱い説明書
  • ユニバーサルジョイントの選定手順
  • ご注文に際してのお願い

BC861

in case angle of the attachment parts cannot be set by BC860
cad
Part No. Color ballφ φD2 F C P 2-M x valid
BC06- 861 W/B φ6 φ13 8 20 9 M3×5
BC08- φ8 φ15 10 M3×6
BC09- φ9
BC10- φ10 11
BC12- φ12 φ22 14 25 12 M4×8
BC13- φ13 15
BC15- φ15 φ25 18 30 15 M5×10
BC16- φ16 20
BC19- φ19.05 φ29 21.5 40 16 M6×12
BC20- φ20 23 18
※You may download 3D CAD drawings by clicking on the part number of interest.
How to assemble
Joint-ball
Steel plate, steel screw and spring are enclosed, if you purchase Joint-base.
Note
This will not be recovered if the slit part is expanded too much. Please make sure on your work.
  • First of all, remove cap screw on slit side
  • Screw the set screw from the opposite side. Please make sure the top of screw is not appeared within slit.
  • As indicated on the above figure,insert and position steel plate(less than 0.9mm) and tighten lightly the cap screw with your other hand.
  • Drop the attached spring into the center of the hole.
  • Tighten the aforesaid cap screw by hexagon wrench so that slit part is opening. Push into joint-ball suitably orif not going through, tighten the cap screw a little and push again and repeatedly.
  • If joint-ball is inserted, loosen the cap screw and remove the steel plate.
  • Check if joint-ball can move smoothly and remove the cap screw afterward.
  • Screw the cap screw (1.) into the original position (the opposite side) and finish.
We can assemble on behalf of you, if required