BC858
spheremotion in 2 points enables the object attachment to flexibly moves
| Part No. | Color | ballφ | φD | L | C | |
|---|---|---|---|---|---|---|
| BC06- | 858 | W/B | φ6 | φ6 | 21 | 6 |
| BC08- | φ8 | φ8 | 27 | 8 | ||
| BC09- | φ9 | φ9 | 30 | 9 | ||
| BC10- | φ10 | φ10 | 33 | 10 | ||
| BC12- | φ12 | φ12 | 39 | 12 | ||
| BC13- | φ13 | φ13 | 42 | 13 | ||
| BC15- | φ15 | φ15 | 48 | 15 | ||
| BC16- | φ16 | φ16 | 51 | 16 | ||
| BC19- | φ19.05 | φ19 | 60 | 19 | ||
| BC20- | φ20 | φ20 | 65 | 20 | ||
※You may download 3D CAD drawings by clicking on the part number of interest.
How to assemble
Joint-ball
Joint-ball
Steel plate, steel screw and spring are enclosed, if you purchase Joint-base.
Note
This will not be recovered if the slit part is expanded too much. Please make sure on your work.
- First of all, remove cap screw on slit side
- Screw the set screw from the opposite side. Please make sure the top of screw is not appeared within slit.
- As indicated on the above figure,insert and position steel plate(less than 0.9mm) and tighten lightly the cap screw with your other hand.
- Drop the attached spring into the center of the hole.
- Tighten the aforesaid cap screw by hexagon wrench so that slit part is opening. Push into joint-ball suitably orif not going through, tighten the cap screw a little and push again and repeatedly.
- If joint-ball is inserted, loosen the cap screw and remove the steel plate.
- Check if joint-ball can move smoothly and remove the cap screw afterward.
- Screw the cap screw (1.) into the original position (the opposite side) and finish.
We can assemble on behalf of you, if required
